|ST50 sensor is made of junction of two kinds of metals of the C and the A. The sensing point is very small as the drawing. In case of setting of the sensor to the BGA or the board, it must be able to be made to just position.
Furthermore, the sensor must be fixed firmly to the BGA or the board. If it is not setting firmly, the temperature curve will shake. If it is right, the temperature curve will be gently-sloping.
|ST50-300||CA-K 0.35t x .67W x 300mm x 5 pieces|
|Temperature||0---300 C degrees|
|Special Lead Cable||1M x 5 pieces|
|Connector of the cable||Clip connector + CMP plug|
|ST50-2 High Temp. Tape||12Wmmx10M x 1 volume|
|Thermo Couple||CA-K 50µ|
Temperature measuringThe best sensor position of the temperature measuring at reworking is A. In the case, the sensor must be inserted to the hole of the board. but it will be difficult when reworking. Therefore, we recommend of the point B by the sensor of ST50, in this case, The temperature will be possible at the almost same as at point A. It is because, MS9000SAN ITTS is operated so that B and C points may almost equal. therefore, B is almost same as A.
|ST50-100 type sensor is 107mm length. . It can be shipment of 5 pieces in one package. other specification is same as ST50-300.
ST51S has a very narrow end.It is suitable as a temperature sensor for fine parts. A connection lead is in common.